HobbyPCB.com

Built by Hobbyist for Hobbyist!
It is currently Mon Aug 19, 2019 3:13 pm

All times are UTC - 5 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: USB serial parameters
PostPosted: Sun Jan 03, 2016 4:20 pm 
Offline

Joined: Sun Jan 03, 2016 3:27 pm
Posts: 2
Hi all

I'm looking to get some software written for PC readout / setting of the Hardrock 50, I have my hardrock installed remotely and need to change bands / monitor so a requirement for software / networking is required.

What I cannot find at the moment are the USB serial parameters ie baud rate, flow control, stop bits etc

Can anyone help

Jim M0CKE


Top
 Profile  
 
PostPosted: Sun Jan 03, 2016 5:11 pm 
Offline

Joined: Sun Jan 03, 2016 3:27 pm
Posts: 2
Hi All

OK I realised it's set in the Hardrock50

So I have set this to 9600, I have connected the hardrock to the PC and have a com port number, I connected to a raspberry pi and used minicom to check commands etc

Thanks

Jim M0CKE


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group