Radio Shield RS-UV3

The HobbyPCB RS-UV3 radio module is a 144/220/450 MHz FM transceiver board. The RS-UV3 is a low cost transceiver solution for Packet Radio, repeaters, Echolink stations, base station and mobile applications. The RS-UV3 supports multiple interfaces including microphone/speaker, line level audio (soundcard), TTL serial control and Arduino Shield connections. The RS-UV3 has an built-in battery charger and provides conditioned power for the Arduino controller.
SKU: RS-UV3
Price:
Sales price: $89.99
  • Email

RS-UV3 is Currently out of stock.  We hope to have more in stock by the end of October 2017.

Frequency: 144-148, 220-225, 420-450 MHz

Sensitivity:   -120 dBm for 12 dB SINAD
TX Power: 23 dBm +- 1dB
Spurious Emissions: -60 dB or lower
DC input: 9.5 - 15V, 100 mA RX, 250 mA TX
Size: 4.7" X 2.9"

Supports ARDUINO, RASPBERRY PI, WINDOWS, LINUX, MAC and others

  • Simple serial interface, no complicated library/drivers required
  • Built-in level shifters for 5V or 3.3V serial lines for direct connection to ARDUINO and RASPBERRY PI 

Stand-Alone operation 

  • Many applications require no external processor at all
  • On board support for beacon, repeater, single channel voice, Echolink, APRS and Packet
  • Legacy support of old analog single board RX and TX with higher performance and lower price

Superior RF performance 

  • Qorvo LNA and PA MMICs for low noise figure and stable output power
  • individual low-pass filters for each band to exceed FCC Spurious requirements
  • Custom RX filter to reject out-of-band signals and level the gain across the 3 bands

Multiple Audio interfaces

  • line level in and out with firmware adjustable levels
  • 3.5mm TRRS jack for PTT Speaker/Mic
  • connections for internal speaker, electret microphone and PTT switch

Flexible Power Options

  • Wide range input voltage (9 - 16V)
  • On-board charger for 7.2V LION battery pack
  • 48 hour RX, 24 hour TX with 3000mA battery pack
  • Automatic switch-over from battery to DC input
  • Simultaneous charging and operation when external voltage is applied

Product Road Map

  • 3 Band, 5W power amp, Shipping February 2015
  • Sub-receiver, Shipping May 2016

Software Support

 

For more detailed information check out the User Manual in the RS-UV3 Files section of our site.

*** Enclosure Sold Separately - NOW AVAILABLE **

 

Saturday, 12 September 2015
After some initial teething problems, some mine and some in the firmware, I liked mine enough to buy two more! I am using using DTMF tones. The second project is a simple, repeater power controller using DTMF tones and controlled by an Arduino Pro Micro. The third one - Who knows?
Friday, 19 June 2015
I was able to make mine work within an hour of getting the package. Used command line and parts lying around the workbench. Manual needs to suggest type of speaker mic expected (I assume it's the Yaesu single plug type). There is no header installed for the USB interface Suggest pointing out the DigiKey part numbers for the 6 pin header and USB - TTL adapter. TX is whistle-clean on the spectrum analyzer. Waiting for the Windows control program. Note: typing an error on the com console requires a recovery step; no interpreter is available.

RS-UV3 Speaker Mic
Sales price: $15.00

12V 1A DC Power Supply Unit
Sales price: $10.00

RS-UV3 Tri-band Antenna
Sales price: $15.00

RS-UV3 Enclosure
Sales price: $30.00